Rabu, 17 April 2013

How to UTP cable crimping

Here I will give know about how mengcriping utp cable ....
Before starting, of course we must have the tools to mengkrimping like:
• Tank Crimping
• UTP Cable
• RJ-45 connector
• Cable Tester



Tank Crimping

Tank krimping is a tool to cut UTP cable and connector to clamp the end, and this is very important for us who want to learn how to mengkrimping cable, this tool is almost the same shape with regular tank that we often see or meet. And below is a picture of a tank crimping:

 

UTP cable

UTP cable we need to use the Internet network to another channel, and in the UTP cable inside the cable there are 8 pieces of small colorful, and the color of the existing small wires inside the UTP cable:


UTP CABLE-SEQUENCE SEQUENCE (Straight and Cross):
Here is a sequence of cabling Straight:

 
A tip of

    1. White Orange
    2. Orange
    3. White Green
    4. blue
    5. White Blue
    6. green
    7. White Chocolate
    8. brown

end B

    1. White Orange
    2. Orange
    3. White Green
    4. blue
    5. White Blue
    6. green
    7. White Chocolate
    8. brown
  

 Here is a sequence of cabling Cross:
A tip of

    1. White Orange
    2. Orange
    3. White Green
    4. blue
    5. White Blue
    6. green
    7. White Chocolate
    8. brown

end B

    1. White Green
    2. green
    3. White Orange
    4. blue
    5. White Blue
    6. Orange
    7. White Chocolate
    8. brown




connectors
Peripheral connectors is that we put on the ends of UTP cable for the cable tujuanya can we put on the LAN port.

 

Kita harus mempunyai konektor RJ-45 untuk dipasangkan pada ujung kabel UTP. dan alat ini sangat berguna sekali.

Cable Tester
Cable Tester is a tool to test the results krimpingan us, but if we are wrong then krimpingan Cable Tester lights will not turn on and if the results are correct then we krimpingan in Cable Tester lights will turn on automatically, so it is unbelievably useful tool for us to know krimpingan our results, the following sample images Cable Tester:
    

here I will make the cable Straight Practice
• Peel the end of the UTP cable, approximately 2 cm
• Open the cable strands, straighten and urutankan compliant cables TIA / EIA 368B
• Once the order is according to the standard, cut and flatten the ends of the cable,
• Put the cable is straight and aligned into the RJ-45 connector, and make sure all cables are correct position.
• Make use of crimping tools crimping, press crimping tool and make sure all the pins (brass) on the RJ-45 connector has "bite" of each cable.
• When finished at the end of that one, do it again at the other end
• The final step is check the cable that pulled you created earlier using the LAN tester, how to enter each end of the cable (RJ-45) to masing2 LAN port available on the tester, turn and make sure all of the LEDs light up according to the order cable we make.
• Below is an example of the end of the UTP cable has been installed RJ-45 correctly, the cable sheath (blue) go into the connector, order cable from left to right (in the picture below sequence pin cable starting from top to bottom).

 

How mengkrimping explained RJ45 cable, cable Straight & Cross Order, and also practice Straight cabling. 

Tidak ada komentar:

Posting Komentar